Baron Footrest & Controls_PASSENGER FLOORBOARD COMFORT (Raise-up) KIT For Harley® Touring Models - Manual

Page: 1 BA-7090-06
HARLEY PASSENGER FLOORBOARD COMFORT (Up) KIT -
Harley-Davidson FL Models (1993-2009)
CAUTION! You must use Red Loctite® on ALL bolts that mount to the
frame.
Revision: 3.7 - 03/04/2010
Install Time: 30 minutes
INCLUDED IN THE KIT:
(2) Powder Coated Comfort (Up) Blocks
(2) Powder coated 1-1/2" x 1-3/8" x 1" Baron Spacers
(4) Black Plastic Caps
(4) 3/8"-16 x 1-1/2" Stainless Cap Head Screws
(4) 3/8"-16 x 3" Stainless Cap Head Screws
TOOLS REQUIRED:
5/16" Allen Wrench (High Quality Tool)
INSTRUCTIONS:
READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION
IMPORTANT: USE ONLY A HIGH QUALITY, CORRECLTY SIZED 5/16" ALLEN TOOL TO REMOVE
AND INSTALL THE MOUNTING HARDWARE. DOING OTHERWISE CAN RESULT IN GALLING THE
BOLT HEADS.
1. Using your 5/16" allen wrench, unscrew the Cap head allen bolts attaching the stock passenger floorboard
mount to the frame and remove the assembly. You will reinstall this assembly once the mounts have been
installed.
STOCK MOUNT FEATURES: Notice the floorboard mount has a locating pin that protrudes from the rear
surface. This pin is what keeps the mount from swiveling on the frame. The frame has three threaded holes and
one unthreaded hole on each side. These holes provide the three different floorboard heights the bike offers
stock.
HEIGHT POSITIONS: The Comfort Kit mounts provide you the ability to raise the stock floorboards height
1-1/4" or 2" higher than the highest stock position. This is accomplished by attaching the mounts to the specific
combinations of the threaded holes on the frame.
POSITION #1 - Raises the floorboards 2" by attaching the mounts to the #1 & #2 threaded holes from the top.
NOTE: You must use the rectangular spacer block in order to use the 2" rise position in order to clear the right
exhaust pipe.
POSITION #2 - Raises the height 1-1/4" by attaching the mounts to the #2 & #3 thread holes from the top.
TILTING: You will notice one threaded and one unthreaded hole towards the top of each mount and directly
between these holes is an engraved L & R. These mounts are Left and Right side specific. The locating pin
mentioned in the stock mount features paragraph inserts into the unthreaded hole and locks the floorboard into
its tilted position.
SPACER BLOCKS: These blocks are for optional use.
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]