Baron Fenders & Body Kits_GANGSTER REAR FENDER - Manual

Page: 1 BA-921702-04
Baron Fiberglass Fenders
Revision: 1.2 - 07/27/2010
INCLUDED IN THE KIT:
(2) 6/32" x 3/4" Button Head Phyllips Screw
(2) 6/32" Flat Washer
(2) 6/32" Well Nut
(4) M6 Fender Washer
(4) M6 Nylock Nut
(8) M8-1.25 Serrated Flange Nut
(1) Rear Gangster Fender Kawasaki VN2000
INSTRUCTIONS:
Hints, tips and precautions on installation and use of Baron Fiberglass Fenders.
Pre-fit all fenders BEFORE you paint them.
Fenders can be trimmed/cut with a cutoff tool or dremel.
Check clearance on lowered rear suspensions with the rear fully collapsed.
Check front fender for corner clearance, forward control clearance, tool bag clearance.
Check rear caliper for clearance (rear caliper can be relocated on some models).
Check tire clearance.
Are you frenching-in lights or license? Check the clearance.
Drill any holes you need for seat mounting, pillion brackets, luggage mounting, light mounting, fender
trim, rear racks, license mounting, etc. prior to painting.
Sand gel coat with 320 grit and prime.
Finish sand primer with 400 wet/dry paper and apply base coat.
Pre mount fender before you paint!
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]