Baron Footrest & Controls_PASSENGER FLOORBOARD COMFORT (Lower-down) KIT For Harley® Touring Models - Manual

Page: 1 BA-7090-05
HARLEY PASSENGER FLOORBOARD COMFORT (Down) KIT
- Harley-Davidson FL Models (1993-2009)
Revision: 1.5 - 12/22/2009
Install Time: 30 minutes
INSTRUCTIONS:
CAUTION! You must use Red Locktite® on the bolts that mount the FL UP mounts to the frame READ
INSTRUCTIONS BEFORE STARTING INSTALLATION
WARNING: USE ONLY A HIGH QUALITY CORRECLTY SIZED 5/16" ALLEN TOOL TO REMOVE
AND INSTALL THE MOUNTING HARDWARE, DOING OTHERWISE CAN RESULT IN GALLING THE
BOLT HEADS.
1. Using your 5/16" Allen wrench, unscrew the Cap Head Allen Bolts attaching the stock passenger floorboard
mount to the frame and remove the assembly from both sides of the bike. You will reinstall this assembly once
your new FL mounts have been installed.
STOCK MOUNT FEATURES: Notice the floorboard mount has a locating pin that protrudes from the rear
surface; this pin is what keeps the mount from swiveling on the frame. The frame has three threaded holes and
one unthreaded hole on each side. These holes provide the three different floorboard heights the bike offers
stock.
HEIGHT POSITIONS: The new FL mount provides you the ability to lower the stock board height to positions
lower than the lowest position the stock mounts allow. This additional lowering is accomplished by attaching
the new FL mount to the frame using the lower mount points.
TILTING: You will notice the new mount blocks have one threaded through hole, one unthreaded through hole
and one unthreaded shallow hole centered under one another. Flipping the mount over you will notice the same
three holes but the bottom shallow hole is offset. The offset hole allows the floorboards to be attached in a tilted
position. The mounts are engraved with our part number and an L & R on only one the side of the mounts
where all holes are centered. The mounts are Left and Right side specific so you must be sure to place them on
the proper side of the bike. The locating pin mentioned in the Stock Mount paragraph above inserts into the
unthreaded hole and locks the floorboard into position. This mount can be attached so the floorboards will
mount flat or tilted for added comfort and control.
RECOMMENDATION: For the most comfort and leg room attach the FL mount to the third threaded hole in
the frame with engraving facing the frame to use the tilted position.
2. If you want them tilted, be sure to have the correct Left or Right FL mount and then face the engraving
towards the frame, this will place the shallow offset hole towards the front side of the bike. If you want the
floorboards to sit flat then face the engraving away from the frame and the lower unthreaded shallow hole will
be centered under the others.
3. Install a lock washer on the 3/8-16 x 1 3/4" bolt and insert it into the through hole of the FL mount and
thread it into the #3 or #2 hole on the frame and tighten to snug, align the lower threaded through hole with the
#4 unthreaded" hole in the frame.
4. Take the stock mount with floorboard attached and align its locating pin with the shallow hole in the FL
mount, insert a lock washer on the 3/8-16 x 1 3/4" Dog-point bolt (the one with machined end) align the upper
mount hole with the threaded hole of the FL mount, insert and thread the bolt and thread until the machined
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]