Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1204 - Manual (Page 33)

28 PNEG-1204 Enclosed Belt Conveyors
Belting Assembly
4. Belt tracking adjustment is initiated by mov-
ing the bearing adjustment bolts. These are
located on both sides of the head and tail
sections. Belt tracking adjustments are made
by adding or removing shims under bearing
as necessary. DO NOT use take-up rods to
correct belt tracking.
5. Adjustment of the idlers is done by loosening
eight bolts. These bolts hold the bearings in
place and are located on both sides of the
conveyor sections (four on each side). After
loosening these bolts, the end of the idler can
shift either forward or backward.
Tracking Adjustment
Loosen these
four nuts on
both sides for
adjustment.
Bearing
Adjustment
Bolts
Bearing
Adjustment
Bolts