Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1204 - Manual (Page 24)

19 PNEG-1204 Enclosed Belt Conveyors
Belting Assembly
15. Install the front drive guard panel over the four
corner mounting studs. Secure with washers
and nuts provided.
16. Fill the shaft mount reducer with the
manufacturer’s recommended oil.
(See Page 41.)
17. Grease bearings on head, tail and idlers.
Lubricate bearings according to bearing
manufacturer’s recommendations.
(See Page 52.)
Front Guard Panel
Lubricate Reducer Drive
Grease Idler
Bearings
Grease
Bearing
Housing
Lubricate Bearings
FINDING BELT CENTER LINE
1. To find the belt center line, measure the belt
width at five points. Starting near the end of
the belt, measure the belt width in 10" inter-
vals, marking them as you measure. Each
measurement shall then be divided in two
and marked. Using a straight edge, draw a
center line using the points as a guide. (See
diagram at right)
10” 10” 10” 10”
Belt Width
Center Point of Width Measurements
Centerline Belt End