Veris Industries SDI SERIES Install User Manual

Page 19

5. Program parameters using diagram below as a reference.

Step #1

Table B.

Enter in a “K” number
found in

Step #2

Table B.

Enter in a “offset” number
found in

Step #3

Table A.

Enter in a Reference
number found in

Step #4
Select the desired
flow rate and total
units.

Step #5
Select the desired
display readout mode.

Step #6
Optional setting, Enter in
the gallons/pulse and
select pulse width. Skip
this step if not using the
Scaled pulse output

Step #7
Press Send to transmit
calibration data to the SDI
Sensor. See Note #1

Press to retrieve
calibration data
from SDI.

Press to reset all parameters
back to factory defaults. Send
must be pressed to send this
data to the SDI.

Step #8

See Note #2

Press to exit parameters
screen and to go back to the
main screen.

Note #1

After the “send” button is pressed the unit could take up to one and a half minutes to program

the Battery Powered SDI. The illustration below shows the programming process bar. When the

programming process bar disappears and the status bar says “updated” the Battery Powered SDI

is programmed.

Programming
Process Bar

Status Bar

Note #2

After the “exit” button is pressed it takes about 10 seconds to go back to the operating display and

refresh flow rate and flow total.