Veris Industries SDI SERIES Install - Manual (Page 13)

12 12 13
Programming
Programming the Series SDI is accomplished by installing the Data Industrial programming software on a computer
and entering data on templates of the Windows ® based program.
1. Load the interface software into the computer.
2. Connect the computer to the SDI with the Data Industrial A-301 communications cable to the socket labeled “D.I.C
Comm Port”, taking care to properly align the tab on the plug and socket to maintain polarity. Connect the DB9
connector of the Data Industrial A-301 communications cable to the PC com port of a PC that has the SDI soft-
ware installed.
3. Connect the Series SDI Flow Sensor to a power supply.
4. Open the interface software and select the appropriate COM PORT as shown in the dialog box below.
5. Open the Parameters Screen as shown below.
OR
To go to the calibration settings
screen select “parameters” from
either place shown.
To go to the calibration settings
screen select “parameters” from
either place shown.