Veris Industries SDI SERIES Install - Manual (Page 18)

18 18
Battery Powered SDI Programming
Programming the Series SDI is accomplished by installing the Data Industrial programming software on a
computer and entering data on templates of the Windows ® based program.
1. Load the interface software into the computer.
2. Connect the PC to the SDI with the Data Industrial A-303 communications cable. Plug in the the RJ11
plug on the A-303 cable to the RJ11 socket on Battry Powered SDI. Connect the DB9 connector of the
A-303 cable to the PC com port to a PC that has the SDI software installed.
3. Open the interface software and select the appropriate COM PORT as shown in the dialog box below.
4. Open the Parameters Screen as shown below.
To calibrate select
“parameters” from
either place shown.