Installation guide, Troubleshooting, China rohs compliance information – Veris Industries EA10 SERIES Install User Manual
Page 15
ZL0102-0A
PAGE 15
©2012 Veris Industries USA 800.354.8556 or +1.503.598.4564 / [email protected]
05126
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
TM
INSTALLATION GUIDE
EA10 SERIES
TROUBLESHOOTING
Problem
Solution
Communications unit power LED is off.
Check that the control power wiring is connected and power is between 24 and 42 VDC.
Communications unit status LED blinks red.
Check all 20-pin connectors between the communications unit and each current sensing modules.
Communications unit status LED is steady red.
Contact Veris technical support.
Communications unit status LED blinks green once for each current sensing
module, followed by one red blink.
The communications unit detects more than four current sensing modules connected. Turn off power to the
device and strings, remove all sensing modules in excess of four, replace endcap on the last unit, and restore
power.
Rx/Error LED is blinking red.
Communications unit received an unusable data packet. Check that the configuration of the communications
unit DIP switches for baud rate and parity match that of the Modbus master.
Check that the bus is terminated on both ends, with biasing pull-up and pull-down resistors.
Current sensing module status LED is steady red.
Contact Veris technical support.
Current sensing module status LED blinks red.
Not configured. Check all 20-pin connectors between the communications unit and each current sensing
modules.
Number of detected current sensing modules (register 40354) does not match
the number of communicating current sensing modules (register 40355).
Check all 20-pin connectors between the communications unit and each current sensing modules.
CHINA ROHS COMPLIANCE INFORMATION
部件名称
产品中有毒有害物质或元素的名称及含量Substances
铅 (Pb) 汞 (Hg)
镉 (Cd)
六价铬 (Cr(VI))
多溴联苯(PBB)
多溴二苯醚(PBDE)
电子线路板
X
O
O
O
O
O
O = 表示该有毒有害物质在该部件所有均质材料中的含量均在 SJ/T11363-2006 标准规定的限量要求以下.
X = 表示该有毒有害物质至少在该部件的某一均质材料中的含量超出SJ/T11363-2006标准规定的限量要求.
Z000057-0A