Veris Technologies VIS_NIR Spectrophotometer Probe - Operating Instructions User Manual
Page 39
OM17-P4000VIS-NIR
5-2
Figure 1
5) Using the
“L” straps as templates, you can drill the hole through the bottom side
of the skid frame rail. Tip: If you start out with small pilot holes (
1/4”or less) it
takes less effort to drill through the bed and frame rail, then drill out to full
dimension from on top.
6) If for some reason you must locate one or two of
lower “L” mounts ahead or
behind the skid frame rail, you can fabricate some clips to hold down in place.
Ideally at least two bolts should go through the skid frame to ensure that probe is
properly connected to bed (Figure 3)
7) Securely bolt down and connect power cable to battery of vehicle.
Figure 1
Figure 2A & B
Start out with ¼”
pilot hole for
drilling up through
bed, then enlarge
to ½” or larger
from on top
Top View
Figure 3
Figure 4