Veris Technologies VIS_NIR Spectrophotometer Probe - Operating Instructions - Manual (Page 22)

OM17-P4000VIS-NIR
4-1
Section 4
Field Operation - Electronics
Operating software - This will need to be completed every time the software is started.
Open Veris operating software:
Figure 1
Figure 2
Folder icon to select working directory.
A field folder must be selected before
any steps can be completed. Note:
Each field or site must have its own
folder.
Once the desired
directory is found,
click on current folder.
BEFORE STARTING:
1. Before taking any
data let system run
for 20 minutes to
allow the
spectrometers to
stabilize.
2. Connect
spectrometers to
PC.
3. Open Veris software
4. The port order must
be set (see Setting
Port Order). This
needs to be done
the first time the
software is run on a
machine, after that
the port order will be
stored for future use.
Port terminology
may be labeled
COM or ASRL.
Both are acceptable
if port number is
correct.
Press EXIT or F12 when ready to quit the software; this will
ensure the port order will be saved.
Set software for either probe or shank mode. If the
incorrect mode is selected and system check or
acquisition entered, then the auxiliary case will need
to be reset by shutting off power and turning back on
before entering software again.