Ohaus AS Series Electronic Balances - Manual (Page 62)

28
TYPE APPROVED BALANCE SEALING TYPE APPROVED BALANCE SEALING TYPE APPROVED BALANCE SEALING TYPE APPROVED BALANCE SEALING TYPE APPROVED BALANCE SEALING
The AS60C balance contains parts used by local Weights and Measures officials for
type approved sealing. Parts include a bracket, lead seal and wire, wrench and a
security screw.
After the balance has been set up properly and the menus are locked out (LFT menu
selection set ON), proceed as follows to seal the balance:
1. Turn OFF and unplug the balance. Remove the Draft Shield, Spill Ring and Pan.
2. Turn the balance over and locate the access hole to the lock out switch.
3. Remove the existing screw next to the access hole and discard.
4. Place the Bracket supplied over the access hole and secure with the Security
Screw supplied. Tighten with the Wrench supplied.
5. Obtain the Lead Seal and wire. Pass the wire through the Security Screw and
the eyelet on the Bracket as shown in the illustration.
6. Crimp the lead seal tightly. Turn the balance over and reinstall items removed.
BASE OF BALANCE
BRACKET
SECURITY SCREW
LEAD AND WIRE SEAL