Ohaus AS Series Electronic Balances - Manual (Page 43)

9
OPERATION OPERATION OPERATION OPERATION OPERATION
Turning the Balance ON Turning the Balance ON Turning the Balance ON Turning the Balance ON Turning the Balance ON
With no load on the pan, switch the bal-
ance ON by pressing . When first
switched ON, all segments of the display
should be on as shown in the illustration.
This display check will be displayed briefly,
then the model number of the balance
followed by a software revision number.
Warm Up Warm Up Warm Up Warm Up Warm Up
Before initally using the balance, allow
time for it to adjust to changes in environ-
ment. The balance need only be plugged
in to warm up. Recommended warm up
period is 30 minutes.