M&C TechGroup SP180-H Operator's manual - Manual (Page 10)

10 Gas sampling and gas conditioning technology 2.7a-ME
The following cross-sectional drawing shows the probe SP180-H.
Figure 1 Dimensions and construction of the SP180-H
11 RECEPTION
The gas sample probe normally is delivered in two packaging units:
1.
The gas sample probe with the required screws, nuts and flange sealing.
2.
Sample tube with gasket.
The gas sample probe should be removed carefully from the packaging and checked immediately for
completeness against the delivery note.
Check the goods for any damage incurred during transport and if necessary inform your transport
insurer of any damage.