6 sending a selection of clips, Purpose, Transfer limitation – EVS IPBrowse Version 6.0 - November 2012 User's Manual User Manual
Page 82: How to send a selection of clips, 7 transfer status monitoring, Transfer status information, Transfer monitoring view, Sending a selection of clips, Transfer status monitoring, 7 ‘transfer status monitoring

Issue 6.0.B
IPBrowse Version 6.0 – User Manual
EVS Broadcast Equipment – November 2012
74
8.3.6 Sending a Selection of Clips
Purpose
If you only want to transfer some clips from a bin rather than an entire bin, you can make
a selection and select your target.
Transfer Limitation
If some clips from the selection do not have a hi-res element, all the clips will be
transferred except those ones.
How to Send a Selection of Clips
To send a selection of clips from a bin, proceed as follows:
1.
From the bin tab, select the clip(s) you want to transfer.
2.
Right-click the list.
A contextual menu is displayed.
3.
Select Send to.
A sub-menu shows the list of targets.
4.
Select the target you want to send your clips to.
The clips transfer is initiated. In this case, individual transfer requests are sent for each
clip from the selection.
8.3.7 Transfer Status Monitoring
Transfer Status Information
Information on the transfer status is available from different areas:
•
in the Bins pane. Refer to section 8.3.2 ‘Transfer Options’ on page 70.
•
in the Transfer Monitoring view.
Transfer Monitoring View
The Transfer Monitoring view provides detailed information on the transfers would they
be scheduled, on-going, finished or failed.