None key, Configuring a none key, Line keys, programmable keys, and softkeys – AASTRA 6735i User Guide EN User Manual
Page 120
Line Keys, Programmable Keys, and Softkeys
113
41-001451-00 REV01 – 06.2013
None Key
You can set a softkey, programmable key, or expansion module key to force a blank entry on the IP phone display for a
specific key. You do this by setting the key to "none". The keys are added in order (from key1 to key20) after any hard-
coded keys have been added. If a particular key is not defined, it is ignored. For more information about key behavior, see
on
Configuring a None Key
Use the following procedure to configure a None key on the 6735i IP Phone. The procedure shows the softkey screen as
an example.
Note:
If you enable global DND on the phone, the incoming multicast RTP session is dropped.
Aastra Web UI
1.
Click on Operation->Softkeys and XML.
or
Click on Operation->Programmable Keys.
or
Click on Operation->Expansion Module
Softkeys
2.
Select from "Key 1" through "Key 20".
3.
In the "Type" field, select None.
Programmable Keys
4.
Select from "Key 1" through "Key 6".
5.
In the "Type" field, select None.
Expansion Module Keys
6.
Select from “Key 1” through “Key 36” (M670i).
or
Select from “Key 1” through “Key 60” (M675i).
7.
In the "Type" field, select None.
8.
Click Save Settings.