Hazard avoidance – Garmin G1000 Mooney M20TN User Manual
Page 330
![background image](/manuals/250553/330/background.png)
Garmin G1000 Pilot’s Guide for the Mooney M20M/M20R/M20TN
190-00647-02 Rev. A
316
HAZARD AVOIDANCE
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
Unlighted Obstacle
Lighted Obstacle
Potential
Impact Points
Obstacle Location
< 1000’ AGL > 1000’ AGL < 1000’ AGL > 1000’ AGL
WARNING: Red obstacle is above or within
100’ below current aircraft altitude
CAUTION: Yellow obstacle is between 100’
and 1000’ below current aircraft altitude
Table 6-10 TAWS Obstacle Colors and Symbology
TAWS information can be displayed on the following maps:
• PFD Inset Map
• Navigation Map Page
• TAWS Page
• Trip Planning Page
• Flight Plan Pages
Displaying terrain and obstacle information (maps other than the TAWS Page):
1)
Press the MAP Softkey (for the PFD Inset Map, press the INSET Softkey).
2)
Press the TERRAIN Softkey to display terrain and obstacle data.
When TAWS is selected on maps other than the TAWS Page, an icon to indicate the feature is enabled for
display and a legend for TAWS terrain colors are shown (Figure 6-67).
The Navigation Map Page Setup Menu provides a means in addition to the softkey for enabling/disabling
display of terrain and obstacles. The setup menu also controls the map range settings above which terrain and
obstacle data are decluttered from the display. If a map range larger than the map range setting is selected, the
data is removed from the map.
Terrain data can be selected for display independently of obstacle data; however, obstacles for which warnings
and cautions are issued are shown when terrain is selected for display and the map range is within the setting
limit.
Maps besides the TAWS Page use settings based on those selected for the Navigation Map Page. The maximum
display ranges for obstacles on each map are dependent on the range setting made for the Navigation Map. If
the maximum range for obstacle display on the Navigation Map is adjusted to below 20 nm, the highest obstacle
display range settings on the other applicable maps are also adjusted proportionally.