Philips HR7766 - Manual (Page 10)

Blade unit
You can use the blade unit to chop, mix, blend or puree ingredients.
1 Remove the protective cover from the blade (Fig. 8).
The cutting edges are very sharp. Do not touch them.
2 Put the blade unit on the tool holder and put the tool holder in the bowl (Fig. 9).
3 Put the ingredients in the bowl. Pre-cut large pieces of food into pieces of approx. 3 x 3 x
3cm. Put the lid on the bowl.
4 Put the pusher in the feeding tube.
5 Set the control knob to speed 2 to switch on the appliance.
- The process continues until you set the control to O.
- To process ingredients briefly, turn the control knob to PULSE one or more times.
tips
- When you chop onions, turn the control knob to PULSE a few times to prevent the onions
from becoming too finely chopped.
- Do not let the appliance run too long when you chop (hard) cheese or chocolate. Otherwise
these ingredients become too hot, start to melt and turn lumpy.
- Do not use the blade to chop very hard ingredients like coffee beans, turmeric, nutmeg and ice
cubes, as this may cause the blade to get blunt.
- The standard processing time for all chopping jobs is 30-60 seconds.
- If food sticks to the blade or to the wall of the bowl, switch off the appliance and unplug it. Then
use a spatula to remove the food from the blade or from the wall of the bowl.
Discs
Never process hard ingredients like ice cubes with the discs.
The cutting edges of the discs are very sharp. Do not touch them.
1 Put the tool holder in the bowl (Fig. 10).
2 Place the desired disc on top of the tool holder (Fig. 11).
3 Assemble the lid onto the bowl.
4 Put the ingredients in the feeding tube.
- Pre-cut large ingredients into chunks that fit in the feeding tube.
- Fill the feeding tube evenly for the best results.
- When you have to process a large amount of ingredients, process small batches and empty the
bowl between batches.
5 Set the control knob to speed 1 to switch on the appliance.
- The process continues until you set the control knob to O.
6 Press the pusher lightly onto the ingredients in the feeding tube.
adjustable slicing disc
The adjustable slicing disc has a very sharp cutting edge. Do not touch the cutting edge.
1 Insert the slicing insert into the top of the carrier (Fig. 12).
2 Insert the knob into the bottom of the carrier (1) and turn it anticlockwise to fix it
(2) (Fig. 13).
3 Turn the adjusting knob to set the slicing disc to the slicing thickness you prefer (Fig. 14).
EnglisH 10