Delta DVP-0204520-03 - Manual (Page 31)

DeviceNet Network Scanner DVPDNET-SL
9.2 Setup of Extended Baud Rate (as slave mode)
1) Connect the relevant devices to the DeviceNet network according to the following figure.
DVP28SV
DVPDNET-SL(Master)
DeviceNet Builder
DeviceNet
DVP28SV
DVPDNET-SL(Slave)
Note:
a. DVPDNET-SL at the bottom of the above figure has been set as slave mode.
b. The node addresses of two DVPDNET-SLs must not be repeated. (See section 2.4).
c. The baud rates of two DVPDNET-SLs are both 500K bps (See section 2.5）.
2) Open DeviceNet Builder software and select “Setup” => “Communication Setting” => “System Channel”,
In result, you can see the following dialog box.
DVP-PLC Operation Manual 28