Delta DVP-0204520-03 - Manual (Page 29)

DeviceNet Network Scanner DVPDNET-SL
9 Setup of Extended Baud Rate
9.1 Setup of Extended Baud Rate (as master mode)
1) Connect the device to the Devicenet network according to the following figure. PC accesses PLC MPU via
RS232 or RS485.
DVP28SV
DVPDNET-SL
DeviceNet Builder
2) Open DeviceNet Builder software and select “Setup” => “Communication Setting” => “System Channel”. And
then the following dialog box appears.
3) Set up the communication parameters in the PC and DVP-SV, e.g. the communication port, address, baud
rate and communication format. Click on “OK” after configuration is finished.
Item Function Default
COM Port COM port on the PC to be used to communicate
with DVP-SV
COM1
Address Communication address of DVP-SV 01
Baud rate Communication speed between the PC and
DVP-SV
9,600 (bps)
Data Bits 7
Parity Even Parity
Stop Bit
Communication protocol between the PC and
DVP-SV
1
Mode
Communication mode between the PC and
DVP-SV
ASCII
4) Select “Network” => "Online” and the following “Select Communication Channel” dialog box will appear. Click
on “OK”.
DVP-PLC Operation Manual 26