Xerox 701P47169 - Manual (Page 194)

FreeFlow Process Manager Operator and Administrator Guide 2-142
Workflow Builder
Copy Count Divisor examples
The following examples illustrate various uses of the Copy Count
Divisor:
Example 1: Original quantity is 20 with 2-up; actual
copies =10
1. The user sets the Copy Count Divisor switch to On.
2. The user creates a workflow with the following nodes:
• Imposition (2up; Always use these settings is set);
• Print (Always use these settings is not set)
3. User submits a job with an XPIF ticket: Copies: 20
4. The job successfully goes through the Imposition node.
5. The job prints 10 actual copies of the imposed document.
Example 2: Original quantity is 20 with 2-up + 2-up;
actual copies = 5
1. The user sets the Copy Count Divisor switch to On.
2. The user creates a workflow with the following nodes:
• Imposition (2up; Always use these settings is set)
• Imposition (2up; Always use these settings is set)
• Print (Always use these settings is not set)
3. User submits a job with an XPIF ticket: Copies: 20
4. The job successfully goes through the two Imposition nodes.
5. The job prints 5 actual copies of the imposed document.
Example 3: Original quantity is 20 with 2-up; observe
changes to Print quantity settings
1. The user sets the Copy Count Divisor switch to On.
2. The user creates a workflow with the following nodes:
• Review
• Imposition (2up; Always use these settings is set)
• Review
• Print (Always use these settings is not set)
3. User submits a job with an XPIF ticket: Copies: 20
4. At the first Review the user opens the Copy Count Dialog.
They will see: Quantity (original document):20
5. At the first Review the user looks at the Print task setting. They
will see: Quantity: 20