Xerox DocuColor 5000 - Manual (Page 84)

DocuColor 5000 Administrator Guide 3-26
3. Profiles
Second Bias Transfer Belt
The Second Bias Transfer Belt is where the image is transferred
from the belt to the paper. The Second Bias Transfer Belt feature
is normally used with heavier weight paper, such as 220 g/m
2
and
greater, 10 pt, or 12 pt, which are just three examples; however
there are times when it is also used with lighter weight paper as
well.
When using either heavier or lighter weight paper, you may want
or need to adjust Side 1 for all 1-sided jobs. If defects continually
occur in a printed job when using heavier weight paper, perform
the following steps to determine if a Custom Paper Profile with
Side 1 or Side 2 (2nd Bias Transfer Belt) adjustments are
appropriate.
1. If the job is printed face down or 1-N, check Side 1 for
defects on the topside (upper portion) of the stacked sheets,
and check Side 2 for defects on the downside (lower
portion) of the stacked sheets.
2.
If the job is printed face up or N-1, check Side 2 for defects
on the topside (upper portion) of the stacked sheets, and
check Side 1 for the downside (lower portion) of the stacked
sheets.