Xerox DocuColor 5000 - Manual (Page 100)

DocuColor 5000 Administrator Guide 3-42
3. Profiles
Decurler Profile procedure
IMPORTANT!
Before using this procedure, use a Decurler A-D
setting to eliminate the curl in our print output; refer to page 3-
34. If a Decurler A-D setting is unsuccessful in eliminating your
curl, evaluate the curl on the output prints (page 3-36). Once you
have measured and recorded the curl on your output, then you
can perform this procedure.
1.
Load a specific Paper Tray with the paper you wish to use
for a job. Make the correct paper selections on the Tray
Properties window for the paper being used and run a few
test prints.
a. If there is too much curl,
save the stack
and continue
to the next step.
b. If the test prints are acceptable, you are finished.
NOTE: For the purpose of this procedure, Paper Tray 1 is used as
the example.
2.
Select one of these Decurler A-D settings from the Tray
Properties window.
3. Run the same print job again, and retrieve the output from
the exit area of the digital press.