Xerox DocuColor 5000 - Manual (Page 80)

DocuColor 5000 Administrator Guide 3-22
3. Profiles
TIP:
The default setting for both Sides 1 and 2 is 100%. It is
recommended that you leave this option at its default setting until
you run test prints and evaluate the output of the prints. Test Print
is discussed in more detail in Running test prints .
NOTE: Refer to page 3-26 for information on the 2nd Bias
Transfer Belt.
14.
If required, choose an Aligner Roll Pressure setting.
TIP:
The default setting is 0. It is recommended that you leave
this option at its default setting until you run test prints and
evaluate the output of the prints. Test Print is discussed in more
detail in Running test prints .
NOTE: Refer to page 3-30 for information on the Aligner Roll
Pressure.