Xerox DocuColor 5000 - Manual (Page 56)

DocuColor 5000 Administrator Guide 2-26
2. System Settings
If you adjust the blowers on the tray to accommodate a particular
type of paper (for example, thin or thick), you want to make
adjustments on the Tray Options window from the Administrator
mode. This will provide optimal output quality of your prints. To
make these adjustments, use the following procedure:
1.
From the System Setting window, select the Tray Options
tab.
2. Select either the desired tray.
3.
From the pull-down menu, select the option which best
correlates with the selected paper for that tray and the
adjustments made to the tray air adjustment levers.
The options include the following:
•
System Default: This option is the default setting. With
this option the paper tray blowers automatically adjust
using settings that are optimized for Xerox papers.
• Multi-Sheet Feed: Select this option if you want the
paper tray blower automatic settings to incrementally
adjust in order to reduce multifeeds.
• Mis-feed: Select this option if you want the paper tray
blower automatic settings to incrementally adjust in
order to reduce misfeeds.
• Custom: With this option, the paper tray blowers are
controlled by parameters that are set by your Service
Representative.
• Always Off: Select this option if you want the paper
tray blowers always switched off; in this mode, the
blowers are not automatically controlled. This mode is
reserved for special media.