Zebra Technologies Z SERIES 79695L-002 - Manual (Page 98)

RFID Operation
Additional Control Panel Parameters 98
79695L-002 Rev. A Z Series ® /RZ™ Series User Guide 6/6/08
View or Change RFID Write Power
This parameter displays the current value for RFID write power.
Default: 16
Selections: 0 to 30
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (-) to scroll through the options.
3. Press SELECT to accept any changes and deselect the parameter.
RFID Error Status
During an error condition, an error message shows on the second line of the
display. This field cannot be modified. For more information on an error
message, refer to the RFID Programming Guide.
Specify RFID Tag Type
Select the RFID tag type that you are using.
Note • RFID transponders operate on different frequencies. You
must use a frequency that complies with local regulations in your
country.
Default: GEN 2 (EPC Class 1, Gen 2)
Selections: GEN 2 (EPC Class 1, Gen 2)
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (-) to scroll through the options.
3. Press SELECT to accept any changes and deselect the parameter.
Table 14 • RFID Parameters (Page 3 of 4)
Parameter Action/Explanation
RFID WRITE PWR
16
RFID ERR STATUS
RFID TAG TYPE
GEN2