Zebra Technologies Z SERIES 79695L-002 - Manual (Page 62)

Operations
Adjust Printhead Pressure 62
79695L-002 Rev. A Z Series ® /RZ™ Series User Guide 6/6/08
2. If necessary, adjust the pressure adjustment dials as follows:
Table 11 • ZM600 and RZ600 Printhead Pressure
Media Width Inside Dial Outside Dial
2 in. (50 mm) 6 1
3 in. (75 mm) 6 2
4 in. (100 mm) 7 3
5 in. (125 mm) 7 4
5.5 in. and up (140 mm and up) 6 6
If the media... Then...
Requires higher pressure to
print well Increase both dials one position.
Shifts left while printing Increase the outside dial setting one position, or
decrease the inside dial setting one position.
Shifts right while printing Increase the inside dial setting one position, or
decrease the outside dial setting one position.
Prints too lightly on the left side
of the label. Increase the inside dial setting one position.
Prints too lightly on the right
side of the label. Increase the outside dial setting one position.