Zebra Technologies Z SERIES 79695L-002 - Manual (Page 74)

Configuration
Standard Control Panel Parameters 74
79695L-002 Rev. A Z Series ® /RZ™ Series User Guide 6/6/08
Select Print Method
The print method parameter tells the printer the method of printing that you
want to use: direct thermal (no ribbon) or thermal transfer (using thermal
transfer media and ribbon).
Default Value: THERMAL TRANSFER
Selections: THERMAL TRANSFER, DIRECT THERMAL
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (-) to scroll through the options.
3. Press SELECT to accept any changes and deselect the parameter.
Set Print Width
This parameter specifies the printable area across the width of the label.
Table 13 shows the ranges and default values for print width, which are
based on the printer model and the printhead resolution.
Note • Setting the width too narrow can result in portions of a label
format not being printed on the media. Setting the width too wide
wastes formatting memory and can cause printing off of the label
and on the platen roller. This setting can affect the horizontal
position of the label format if the image was inverted using the
^POI
ZPL II command.
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (-) to change the value shown.
3. Press SELECT to accept any changes and deselect the parameter.
Table 12 • Printer Parameters (Page 6 of 26)
Language/Parameter Action/Explanation
Table 13 • Print Width Ranges and Maximum Values
Printhead
Resolution
Printer
ZM400/RZ400 ZM600/RZ600
200 dpi Default Value: 832
Range: 2 to 832 dots
Default Value: 1344
Range: 2 to 1344 dots
300 dpi Default Value: 1248
Range: 2 to 1248 dots
Default Value: 1984
Range: 2 to 1984 dots
600 dpi
Note • 600 dpi is
not available on the
RZ400.
Default Value: 2496
Range: 2 to 2496 dots
N/A