Zebra Technologies Z SERIES 79695L-002 - Manual (Page 57)

57 Operations
Load Ribbon
6/6/08 Z Series ® /RZ™ Series User Guide 79695L-002 Rev. A
3. Insert the ribbon into the printer. In this step, follow the instructions for the Thermal
Transfer option installed in your printer.
Ribbon Coated Outside
(black ribbon spindle) Ribbon Coated Inside
(gray ribbon spindle)
a. Hold the ribbon with the loose end unrolling
clockwise. a. Hold the ribbon with the loose end unrolling
counterclockwise.
b. Place the roll of ribbon on the ribbon supply
spindle (
1
) and push it all the way back.
b. Place the roll of ribbon on the ribbon supply
spindle (
1
) and push it all the way back.
c. Pull the end of the ribbon under the printhead
assembly (
1
) and out the front of the printer.
Extend the ribbon approximately 24 in.
(610 mm) out of the printer.
c. Pull the end of the ribbon under the printhead
assembly (
1
) and out the front of the printer.
Extend the ribbon approximately 24 in.
(610 mm) out of the printer.
1 1
1 1