Zebra Technologies Z SERIES 79695L-002 User Manual
Page 75
75
Configuration
Standard Control Panel Parameters
6/6/08
Z Series
®
/RZ™ Series User Guide
79695L-002 Rev. A
ZPL, EPL, APL-I
APL-D only
Set Maximum Label Length
This parameter is used during the media portion of the calibration process.
Always set maximum label length to a value that is at least 1.0 in.
(25.4 mm) greater than the actual label length (
). If the value is set
to a smaller value than the label length, the printer assumes that continuous
media is loaded, and the printer cannot calibrate.
For example, if the label length is 5.0 inches (126 mm) including the
interlabel gap, set the parameter for 6.0 inches (152 mm). If the label length
is 7.5 inches (190 mm), set the parameter for 9.0 inches (229 mm).
Figure 14 • Label Length
Default Value (ZPL, EPL, APL-I): 39.0 inches (988 mm)
Selections (ZPL, EPL, APL-I): Values are adjustable in one-inch (25.4 mm)
increments
Default Value (APL-D): 1200i
Range (APL-D): 0000i to 9999i (o to 99.99 inches)
To change the value shown:
1.
Press
SELECT
to select the parameter.
2.
Press
PLUS (+)
or
MINUS (-)
to change the value shown.
3.
Press
SELECT
to accept any changes and deselect the parameter.
Table 12 • Printer Parameters (Page 7 of 26)
Language/Parameter
Action/Explanation
}
2
1
Label length (including interlabel gap)
2
Interlabel gap
3
Set maximum label length to approximately this value
1
3