Zebra Technologies Z SERIES 79695L-002 User Manual
Page 71
71
Configuration
Standard Control Panel Parameters
6/6/08
Z Series
®
/RZ™ Series User Guide
79695L-002 Rev. A
Adjust the Tear-Off Position
This parameter establishes the position of the media over the
tear-off/peel-off bar after printing.
See
. Higher numbers move the media out (the tear line moves
closer to the leading edge of the next label), and lower numbers move the
media in (the tear line moves closer to the edge of the label just printed).
Figure 13 • Tear-Off Position Adjustment
Default Value (ZPL, EPL, APL-I): 0
Range (ZPL, EPL, APL-I): -120 to +120
Default Value (APL-D): +128i
Range (APL-D): +00i to +999i (inches), 0m to 2537m (metric)
To change the value shown:
1.
Press
SELECT
to select the parameter.
2.
Press
PLUS (+)
to increase the value. Each press adjusts the tear-off
position by four dot rows.
3.
Press
MINUS (-)
to decrease the value. Each press adjusts the tear-off
position by four dot rows.
4.
Press
SELECT
to accept any changes and deselect the parameter.
Table 12 • Printer Parameters (Page 3 of 26)
Language/Parameter
Action/Explanation
1
Media direction
2
Factory-set tear line location at position 00
1
2