Zebra Technologies Z SERIES 79695L-002 - Manual (Page 110)

Routine Maintenance
Routine Maintenance for the Rewind Option 110
79695L-002 Rev. A Z Series ® /RZ™ Series User Guide 6/6/08
Routine Maintenance for the Rewind Option
When you use the Rewind option, you will periodically need to remove printed labels or used
liner from the rewind spindle. You may also need to adjust the media alignment for the Rewind
option.
Remove Printed Labels or Liner from the Rewind Spindle
To remove printed labels or liner from the rewind spindle, complete these
steps:
1. Cut the liner between the media alignment spindle and the rewind spindle.
2. Rotate the take-up spindle counterclockwise until the rewind media guide is fully upright.
3. Loosen the thumbscrew on the rewind media guide.