ZyXEL Communications ZyXEL DMA 1000 - Manual (Page 90)

IES-1000 User’s Guide
11-2 IEEE 802.1p Priority Commands
11.2.2 Regen Port Command
Syntax:
192.168.1.1 vlan1q> regen port [
priority>]
where
= A bridge port number. Valid parameter range = [1 – 9].
= The user priority for a frame received on this port. Valid
parameter range = [0 – 7 or *], where 0 is the lowest priority, 7 is
the highest priority and * means all user priorities.
= The regenerated user priority the incoming user priority is
mapped to for . Valid parameter range = [0 - 7],
where 0 is the lowest priority and 7 is the highest priority.
This command changes the priority of a tagged frame from a specified ingress port from the original user
priority to the regened priority.
To display the regeneration table, simply use the Regen Port command without parameters, as shown next.
192.168.1.1 vlan1q> regen port