ZyXEL Communications ZyXEL DMA 1000 - Manual (Page 37)

IES-1000 User’s Guide
System Commands 5-7
5.7.3 Syslog Server Command
Syntax:
192.168.1.1 sys> syslog server
where
= The IP address of syslog server.
This command sets the UNIX server IP address. If =0.0.0.0 (default), then logs will be
dropped (not be sent).
5.8 System Error Log Commands
The system error log will record error events locally to the IES-1000 memory. You may clear or display these logs
using the commands listed in this section.
The following lists what logs the system error log can record.
ADSL link on (port number, sequence number, rate,
noise margin, attenuation) ADSL link down (port number, sequence number, noise
margin, attenuation)
ADSL OVER_HEAT_ACTIVE (temperature) ADSL OVER_HEAT_RELEASE (temperature)
G.SHDSL link on (port number, sequence number,
rate, noise margin, attenuation) G.SHDSL link down (port number, sequence number,
noise margin, attenuation)
G.SHDSL OVER_HEAT_ACTIVE (temperature) G.SHDSL OVER_HEAT_RELEASE (temperature)
Console session begin Console session end
Telnet session begin Telnet session end
Incorrect telnet password Insecure telnet access (IP address)
FTP session begin FTP session end
Incorrect FTP password Insecure FTP access (IP address)
FTP image error (reason) FTP receive file OK (file name)
System reboot
5.8.1 Errlog Display Command
Syntax:
192.168.1.1 sys> errlog display
This command displays the system error log.
5.8.2 Errlog Clear Command
Syntax:
192.168.1.1 sys> errlog clear