ZyXEL Communications ZyXEL DMA 1000 - Manual (Page 73)

IES-1000 User’s Guide
Bridge Commands 9-7
Figure 9-1 Default VLAN Settings
9.6.1 Portfilter Command
Syntax:
192.168.1.1 bridge> portfilter [ all|]
where
= An incoming bridge port number.
all = All bridge ports are allowed outgoing ports.
= The outgoing bridge ports. Separate by a space if there is more than one
port.
This command sets or displays the port-based VLAN configuration.
An example is shown next.
192.168.1.1 > bridge
192.168.1.1 bridge> portfilter
Port 1 (ethernet): all
Port 2 (dsl1): 1
Port 3 (dsl2): 1
Port 4 (dsl3): 1
Port 5 (dsl4): 1
Port 6 (dsl5): 1
Port 7 (dsl6): 1
Port 8 (dsl7): 1
Port 9 (dsl8): 1
The above shows the current configuration of the port-based VLAN. It is the same as the default settings.
An example with an altered configuration is shown next.
192.168.1.1 > bridge
192.168.1.1 bridge> portfilter 2 1 3
192.168.1.1 bridge> portfilter 3 1 2