beautypg.com

Snmp trap configuration, 4 snmp trap configuration, 4 snmp access list command – ZyXEL Communications ZyXEL DMA 1000 User Manual

Page 100: 1 supported traps, 2 trap add command

background image

IES-1000 User’s Guide

13-4

Remote Management

This command revokes access by any and all manager stations.

13.3.4

SNMP Access List Command

Syntax:

access list

This command shows the allowed access.

13.4 SNMP

Trap

Configuration

The network module uses the SNMP trapping facility to proactively report unusual events to one or more trap
servers. To configure the trap parameters, use the trap commands in the SNMP subsystem. After configuring the
SNMP trap parameters, save the configuration to the nonvolatile memory with the config save command.

13.4.1 Supported

Traps

The network module supports the following traps

♦ coldStart Trap (defined in RFC 1215) :

This trap is sent at system start-up.

♦ authenticationFailure Trap (defined in RFC 1215) :

This trap is sent if a request arrives with an invalid community string.

♦ linkUp Trap (defined in RFC 1215) :

This trap is sent when a DSL port is up.

♦ linkDown Trap (defined in RFC 1215) :

This trap is sent when a DSL port is down.

♦ overheat Trap (defined in ZYXEL-MIB) :

This trap is sent periodically when a network module is overheated.

♦ overheatOver Trap (defined in ZYXEL-MIB) :

This trap is sent when the network module is no longer overheated.

13.4.2 Trap

Add

Command

Syntax:

trap add

where

=

The password used by the network module to authenticate itself to the trap