ZyXEL Communications ZyXEL DMA 1000 - Manual (Page 41)

IES-1000 User’s Guide
G.SHDSL Commands 6-3
This command saves the G.SHDSL configuration into nonvolatile memory. You must use this command to save
any configurations that you make, otherwise the IES-1000 will return to its default settings when it is restarted.
Do not turn off your IES-1000 while saving your configuration.
6.6.2 Disable Port Command
Syntax:
192.168.1.1 gshdsl> disable port
where
= A port number, from 1 to 8
This command forcibly disables the specified G.SHDSL port.
The factory default of all ports is disabled. A port must be enabled before data transmission can
occur. An enabled but disconnected SHDSL port generates more heat than an operating port. To
minimize heat generation and to enhance reliability, remember to disable a port when it is not in
use.
6.6.3 Disable Ports Command
Syntax:
192.168.1.1 gshdsl> disable ports
This command forcibly disables all G.SHDSL ports.
6.6.4 Enable Port Command
Syntax:
192.168.1.1 gshdsl> enable port
where
= A port number, from 1 to 8
This command forcibly enables the specified G.SHDSL port.
6.6.5 Enable Ports Command
Syntax:
192.168.1.1 gshdsl> enable ports
This command forcibly enables all G.SHDSL ports.