ZyXEL Communications ZyXEL DMA 1000 - Manual (Page 48)

IES-1000 User’s Guide
6-10 G.SHDSL Commands
= The VCI setting for the G.SHDSL ports for use with a TX based
network.
= The VPI setting for the G.SHDSL ports for use with Rx based
networks.
= The VCI setting for the G.SHDSL ports for use with Rx based
networks.
The and settings will be equal to those of and if the rx
settings are not configured.
The set pvcs command allows you to configure a single PVC for all of the G.SHDSL ports at once.
6.6.19 Show PVC Command
Syntax:
192.168.1.1 gshdsl> show pvc
where
= A port number, from 1 to 8.
This command allows you to display the PVC parameters of an individual G.SHDSL port
6.6.20 Show PVCs Command
Syntax:
192.168.1.1 gshdsl> show pvcs
This command allows you to display the PVC parameters of all G.SHDSL ports.
6.6.21 Display All G.SHDSL Line Information
Syntax:
192.168.1.1 gshdsl> monitor [ []]
where
= The first port number in a range of ports for which you want to display
line information. 1 is used if you leave this blank.
= The last port number in a range of ports for which you want to display
line information. 8 is used if you leave this blank.
This command displays all G.SHDSL line information. Information is updated every five seconds. Press any
key and then press [ENTER] to stop updating information. Use monitor without any port numbers to display
line information for every port.
6.6.22 Set Central Side Port Bonding Command
Syntax: