Xerox digital copier printer 5750 - Manual (Page 42)

2
2-14 Setting up the DocuColor
Ignore EOF Character
Yes/No [No]
This option appears only if Enable Parallel Port is set to Yes . This option specifies that
the DocuColor should ignore end-of-file (EOF) messages in a file. This option must be
set to
Yes to print PostScript files in binary format (not ASCII); under normal circum-
stances, it should be set to No . When this option is set to Yes , the DocuColor uses the
parallel port timeout value to determine when the end of the file has been reached.
When you have configured the port options, choose another port type, or choose Exit
Port Setup and proceed to Protocol Setup.
Protocol Setup options
TCP/IP Setup options
To configure the DocuColor, choose each protocol and enter the settings for that
protocol. You can enable TCP/IP and IPX/SPX communication simultaneously.
To configure the DocuColor for TCP/IP, choose TCP/IP Setup.
Choose Ethernet Setup and enter the appropriate settings. Choose each network
type you use (Ethernet and/or Token Ring) and enter the appropriate settings.
Token Ring Setup appears as an option only if you have enabled Token Ring in Port
Setup. If your network uses a gateway, enter the gateway address in Gateway Setup.
N OTE : If TCP/IP is running on both an Ethernet and a Token Ring network, it is
assumed that the two networks are already routed to each other. The DocuColor
does not function as a router.
Exit Protocol Setup
TCP/IP Setup
IPX/SPX Setup
Protocol Setup
Exit TCP/IP Setup
Ethernet Setup
Token Ring Setup
Gateway Setup
TCP/IP Setup