Xerox 7232 - Manual (Page 85)

Xerox WorkCentre 7232/7242 System Administration Guide 75
6 UNIX TCP/IP
This chapter explains how to set up the machine to operate in a UNIX TCP/IP
environment. The UNIX Workstation Operating Systems (OS) supported are Solaris,
SunOS, and HP-UX. The following information is provided.
Information Checklist – page 75
UNIX TCP/IP Environments – page 76
UNIX TCP/IP Installation – page 76
Installation Procedure – page 76
Network Communication Setup – page 77
Workstation Setup – page 78
Test Print – page 84
Printing – page 84
Solaris/HP-UX – page 84
SunOS – page 86
Printer Status – page 88
Solaris/HP-UX – page 88
SunOS – page 89
-C Option – page 90
Information Checklist
Before installing the UNIX TCP/IP features on the machine, make sure that the
following items are available or have been performed.
Item By
An existing operational network utilizing a UNIX TCP/IP protocol is
required. These steps are not designed to install the UNIX TCP/IP
network. Customer
SunOS 4.1x, Solaris 1.x, 2.x, 7.x, 8.x, 9.x, 10.x, HP-UX 9.x, 10.x, 11.x Customer
Make sure that the correct IP Address is being used for the machine. Customer
Make sure that the Gateway Address is set correctly. Customer
Make sure that the Subnet Mask (for IPv4) or Prefix (for IPv6) is set
correctly. Customer
Make sure that the Host Name is set correctly. Customer
Test the copy and fax features of the machine, to make sure that they are
installed fully and functioning correctly. Customer