Xerox 7232 - Manual (Page 125)

Xerox WorkCentre 7232/7242 System Administration Guide 115
11 IPP (Internet Printing Protocol)
This chapter explains how to set up the machine to operate in an IPP (Internet Printing
Protocol) environment. The following information is provided.
Information Checklist – page 115
IPP Environment – page 116
IPP Installation – page 116
Installation Procedure – page 116
Network Communication Setup – page 117
Workstation Setup – page 119
Test Print – page 119
Information Checklist
Before starting the IPP installation procedures, make sure that the following items are
available or have been performed.
If problems are encountered during the installation of the machine, refer to the Problem
Solving chapter for assistance.
CAUTION: Do not connect the network cable to the machine until instructed to
do so.
Item By
An existing operational TCP/IP network is required. These procedures
are not designed to install a network. Customer
Obtain and record the following information:
• IP address
• Gateway address
• Subnet mask (for IPv4) / Prefix (for IPv6)
• Host name
Refer to the glossary for additional information about the Gateway
Address and Subnet mask, if needed. Customer
Test the machine to make sure that it is installed fully and functioning
correctly. Customer
Install the print driver. Customer