Xerox 7232 - Manual (Page 81)

NetWare Installation
Xerox WorkCentre 7232/7242 System Administration Guide 71
NetWare Installation
This section describes the installation procedures to use the machine in a NetWare
environment.
Installation Procedure
The installation procedure is as follows.
Network Communication Setup
1. Go to Properties->Connectivity->Port Settings.
2. At the CentreWare Internet Services home page for the machine, select the
[Properties] tab.
3. In the [Properties] frame, click the [Connectivity] folder.
4. Select the plus symbol [+] to the left of the [Port Settings] folder.
5. On the NetWare line, select the [Enabled] box. Select [Apply].
When using IPX:
Set the Netware protocol to [Enabled] using the touch screen or CentreWare
Internet Services.
When using TCP/IP:
Set the Netware protocol to [Enabled] using the touch screen or CentreWare
Internet Services. Set the IP address on the control panel or CentreWare Internet
Services.
For more information, refer to Network Communication Setup on page 71.
NetWare Setup
For more information, refer to NetWare IPX Printing Setup on page 73.
Workstation Setup
For more information, refer to Workstation Setup on page 73.
Test Print
For more information, refer to Test Print on page 73.
Network Communication Setup
Use this procedure to set up the network communication parameters of the machine.
At the machine, perform these steps.