Xerox 7232 - Manual (Page 121)

Xerox WorkCentre 7232/7242 System Administration Guide 111
10 USB Port
This chapter explains how to set up the machine in a USB port environment. The
following information is provided.
Information Checklist – page 111
USB Port Environment – page 112
USB Port Installation – page 112
Installation Procedure – page 112
USB Port Communication Setup – page 113
Workstation Setup – page 113
Test Print – page 114
Information Checklist
Before starting the USB port installation procedures, make sure that the following items
are available or have been performed.
NOTE: The installation procedures will install the machine on the USB port of the host
workstation. The procedures are not intended to connect the host workstation to other
workstations.
If problems are encountered during the installation of the machine, refer to the Problem
Solving chapter for assistance.
CAUTION: Do not connect the USB cable to the machine until instructed to do
so.
Item By
USB Cable Customer
Test the machine to make sure that it is installed fully and functioning
correctly. Customer
Install the print driver. Customer