Setup – Xerox XK25C User Manual
Page 25
10
Getting Started
Setup
(continued)
7
Turn the WorkCentre power switch on. The switch is located on the rear
of the machine, next to the printer ports. Pressing the right, outer side
turns the power on; pressing the left, inner side turns the power off.
Power switch
8
The Control Panel Display will show
000
in a scrolling manner while
the machine is initializing.
9
The Display will show
001
when it is ready for use. Control Panel
mode indicators are set to default values for this setup procedure. When
you first power the machine on and there are no cartridges installed, you
will see the error code
E02
shown in the Display. This means there is
no left (color) cartridge installed. This error code will disappear when you
start the next procedure.
10
Proceed to the next step
Installing & Aligning Ink Cartridges
.