Xantrex Technology XMP 2600 - Manual (Page 110)

System messages Power module setup
APPENDIX
A
System
messages
In the Normal Mode of Operation, the right hand side of the display’s lower row
may show one of the following System Messages:
← select channel → in the Status Mode, use the selection
(right and left arrow) keys to select a
channel.
← Select Item → in the Channel Programming Mode, use
the selection keys to select the item to be
programmed.
PRIMARY OVER TEMP.
a primary Over Temperature fault was
detected. The outputs where disabled and
they will be revived when
the
temperature drops back to the allowed
range.
* MAINS POWER FAIL *
the Mains Power has failed. The outputs
are disabled so that they will not decay.
As power is restored, the Power Supply
undergoes a full reset.
OVER VOLTAGE SHUTDOWN
an Internal Power Module detected a non-
controllable OVP fault. The main
converter was Shutdown.
OVER CURRENT SHUTDOWN
an Internal Power Module detected a non-
controllable OCP fault. The main
converter was Shutdown.
CHNL COMM T.O. SHUTDN
an Internal Power Module failed to
respond to the Main Controller’s queries.
The main converter was Shutdown.
* CHANNEL SHUTDOWN *
a Power Module reported a severe error
and it is defined as Global, so a Shutdown
is initiated due to the Module’s condition
and definition.
OVP & CHNL SHUTDOWN
a combination of the above.
XMP 2600 User’s Guide rev. 1.0 91