Western Telematic SRM-100 - Manual (Page 53)

Register Range Default Function
S95 --- 000 Extended Result Codes. The bits in this register can be set to override some
of the Wn command options. A bit set to 1 in this register will enable the
corresponding result code regardless of the
Wn setting.
Bit
Dec Value Function
0 = 1 CONNECT CODE indicates DCE speed instead of
DTE speed.
1 = 2 Append /ARQ (Automatic Repeat Request) to
verbose CONNECT XXXX result code if protocol is
other than none.
2 = 4 Enable CARRIER XXX result code.
3 = 8 Enable PROTOCOL XXXX result code.
5 = 32 Enable COMPRESSION result code.
Note: To enable more than one function, add up the decimal values of the
desired functions. For example, to enable CARRIER, PROTOCOL, and
COMPRESSION, you would add 32 + 8 + 4 for a total of 44. Therefore, the
command to enable these functions would be ATS95=44.
10-7
SRM-100 - Secure Rack Modem, User's Guide S-Registers