Western Telematic SRM-100 - Manual (Page 51)

Register Range Default Function
S29 0 - 255 --- Flash Dial Modifier Time. Sets the length of time (in hundredths of a
second) that the modem will go off-hook when it encounters the flash (!) dial
modifier in the dial string.
S30 0 - 255 --- Disconnect Inactivity Timer. Sets the length of time (in 10 second intervals)
that the modem will stay on-line before disconnecting when no data is sent or
received. In error-correction mode, any data transmitted or received will
reset the timer. In other modes, any data transmitted will reset the timer.
The timer is inoperative in synchronous mode.
S31 --- --- Bit Mapped Options.
Bit
Option Val Description Cmd
0 Not Used
1 Speed Detection 0 Disabled N0
1 Enabled N1
2,3 Progress Messages 0 DTE Speed W0
1 Full Reporting W1
2 DCE Speed W2
4-7 Not Used.
S32 0 - 255 17 XON Character. Stores the ASCII decimal code for the XON character.
S33 0 - 255 19 XOFF Character. Stores the ASCII decimal code for the XOFF character.
S36 0 - 7 7 V.42 Negotiation Failure Treatment. This register is read when the S48
register equals 128 or if an attempted V.42 connection fails. These fallback
options are initiated immediately upon connection if S48 = 128.
S36=0
Modem Disconnects.
S36=1 Modem stays on-line and a direct mode connection is established.
S36=2 Reserved.
S36=3 Modem stays on-line and a normal mode connection is
established.
S36=4 An MNP connection is attempted. If this connection fails, the
modem then disconnects.
S36=5 An MNP connection is attempted. If this connection fails,
a direct mode connection is established.
S36=6 Reserved.
S36=7 An MNP connection is attempted. If this connection fails, a
normal mode connection is established.
S37 0 - 21 0 Desired Connection Rate.
S37=0
Attempt auto mode connection.
S37=1-3 Attempt to connect at 300 bps.
S37=4 Reserved.
S37=5 Attempt to connect at 1200 bps.
S37=6 Attempt to connect at 2400 bps.
S37=7 Attempt to connect at V.23
S37=8 Attempt to connect at 4800 bps.
S37=9 Attempt to connect at 9600 bps.
S37=10 Attempt to connect at 12K bps.
S37=11 Attempt to connect at 14.4K bps.
S37=12 Attempt to connect at 7200 bps.
10-5
SRM-100 - Secure Rack Modem, User's Guide S-Registers