Western Telematic SRM-100 - Manual (Page 25)

6.1. Add Name / Password
To add new User Passwords and Names to the Password Directory, go to the Edit Password
Directory Menu (/E), type 1 (Add Name / Password) and press [Enter]. The SRM will display
a submenu that contains the following items:
1. Name: This item assigns a Name to each User Password. Note that the SRM will not
prompt callers to enter the User Name in order to log in. This name is used only for
internal accounting purposes; and to associate each password with a specific client or
employee. (Up to 16 characters).
Note: The SRM will not accept duplicate user names or passwords. The unit will
display an error message if you attempt to define a name or password that is already
in use.
2. Password: This item assigns a Password for each user. When a caller attempts to log on
to the SRM, a valid User Password must be entered in order to access the secure device.
(Case sensitive, Up to 16 characters).
3. Dial Back Number: This item can assign a Dial Back Number to each User Password.
If the Dial Back Number is not defined, a caller who accesses the SRM with this User
Password will be granted immediate access to the secure device. If the Dial Back
Number is defined, when a caller enters this User Password, the SRM will disconnect,
call the assigned Dial Back Number, and then allow the answering party to access to the
secure device. (Up to 32 characters)
Notes:
• The SRM can be configured to perform a Dial Back for some User Passwords,
while providing immediate access to other User Passwords.
• While a Dial Back operation is in progress, the SRM is not able to accept
incoming calls, and will not recognize commands entered via the Console Port.
• If the initial call is not successful, the SRM will repeat the Dial Back procedure as
specified by item 12 (Dial Back Attempts) and item 13 (Dial Back Delay) in the
General Parameters Menu (see Section 5.2).
4. Save Entry: This item stores the Password, Name, and Dial Back Number in the
Password Directory. If you are satisfied with the data entered at prompts 1 through 3,
type 4 and press [Enter] to save this information in non-volatile memory.
After each password is saved, the SRM-100 will redisplay the Add Name/Password menu. To
continue to add names and passwords, repeat steps one through four above. If you have
finished adding passwords, press [Esc] to return to the Edit Password Directory Menu.
6-2
SRM-100 - Secure Rack Modem, User's Guide The Password Directory