Western Telematic SRM-100 - Manual (Page 37)

7.5.8. Pass-Through Mode (Console-Modem)
The Pass-Through Mode allows communication between the device connected to the Console
Port and the SRM’s internal modem.
When the Pass-Through Mode is active, the Console Port can access the modem in order to
place outbound calls, or invoke any of the AT commands listed in Section 9.
Note that when the Command Mode is accessed via modem, the Pass-Through Mode can also
allow a remote user to access a control device connected to the Console Port.
To activate the Pass-Through Mode, proceed as follows:
1. Access the Command Mode as described in Section 5.1.
2. When the "SRM>" command prompt appears, type /U and press [Enter]. The Utilities
Menu will appear as shown in Figure 7.2.
3. From the Utilities menu, type 8, then press [Enter] and follow the instructions in the
submenu.
4. To exit from Pass-Through Mode and return to the Command Mode, type /X and press
[Enter].
7-8
SRM-100 - Secure Rack Modem, User's Guide Operation