Western Telematic SRM-100 - Manual (Page 24)

6. The Password Directory
When the SRM-100 is properly configured, each inbound caller will be prompted to enter a
password before being allowed to access the secure device. The Password Directory is
basically a listing of all valid user passwords, user names, and their associated Dial Back
numbers.
The SRM-100 will accept up to 100 User Passwords and one System Password. User
passwords allow access to the secure device connected to the SRM-100 serial Modem Port, and
the System Password allows access to the Command Mode. As discussed in Section 5.2, the
System Password is defined via the General Parameters Menu. The procedure for defining
User Passwords is described in this chapter.
To add passwords to the directory or edit existing User Passwords, make certain the command
mode is active, then type /E and press [Enter]. The SRM-100 will display the Edit Password
Directory Menu shown in Figure 6.1. This menu offers three options; Add Name/Password,
Edit/Delete from List, and Edit/Delete from Search.
After defining the Password Directory, you may wish to review its contents. Section 6.4
describes the procedure for displaying the Password Directory and explains the directory
screen.
Notes:
• User Passwords do not allow access to the SRM Command Mode.
• In order for the SRM to protect access to the secure device, the Security Mode
must be enabled (see Section 5.2) and at least one User Password must be defined.
6-1
EDIT PASSWORD DIRECTORY
1.
Add Name/Password
2. Edit/Delete from List
3. Edit/Delete from Search
Enter Selection,
Press to abort ...
Figure 6.1: The Edit Password Directory Menu